Bootmod3 Data Parameters to Log
For majority of the B58 & S58 platforms, these parameters on BM3 should be available to log and are required to efficiently and quickly dial in your vehicle setup. Remove all default generic parameters that are not listed to be logged below. The ones with a * are vital. * is only needed if it is a flex fuel tune - * are not needed if it is a top mount turbo setup
- Accel. Pedal[%]
- Ambient pressure[psig]
- Boost (Pre-Throttle)[psig]
- Coolant Temp[F]
- Gear[-]
- HPFP (Target)[psig]
- HPFP Act.[psig]
- IAT[F]
- Ignition Cyl 1[deg]
- Ignition Timing 1[deg]
- Ignition Timing 2[deg]
- Ignition Timing 3[deg]
- Ignition Timing 4[deg]
- Ignition Timing 5[deg]
- Ignition Timing 6[deg]
- LPFP Act. (Raw)[psig]
- LTFT[-]
- LTFT Bank 2[-]
- Lambda[AFR]
- Lambda Act.[AFR]
- Lambda Act. (Bank 2)[AFR]
- STFT[-]
- STFT Bank 2[-]
- Throttle Angle[%]
- Vehicle Speed[mph]
- (RAM) Boost Pressure (Target)[psig] *
- (RAM) Boost Setpoint[-] *
- (RAM) Engine Speed[1/min]
- (RAM) HPFP Angle (Base)[Grad KW] *
- (RAM) Ignition Timing Corr. (Total)[°]
- (RAM) Ignition Timing Corr. Cyl. 1[°]
- (RAM) Ignition Timing Corr. Cyl. 2[°]
- (RAM) Ignition Timing Corr. Cyl. 3[°]
- (RAM) Ignition Timing Corr. Cyl. 4[°]
- (RAM) Ignition Timing Corr. Cyl. 5[°]
- (RAM) Ignition Timing Corr. Cyl. 6[°]
- (RAM) Load (Actual)[%]
- (RAM) Load (Limit)[%]
- (RAM) Load (Target)[%]
- (RAM) Pressure Ratio (Turbine)[-]
- (RAM) Rel. Fill Limit (Flag)[-] *
- (RAM) Torque Intervention (TQC)[-]
- (RAM) Torque Intervention (TQW)[-]
- (RAM) Torque Limit (Flag)[-]
- (RAM) Torque Limit Active (Flag)[-]
- (RAM) Torque Limit Active 2 (Flag)[-]
- (RAM) Torque Limit Active 3 (Flag)[-]
- (RAM) Torque at Clutch (Actual)[Nm]
- (RAM) Torque at Clutch (Target)[Nm]
- (RAM) Torque at Clutch (Target) (Pre-DrivDynmcs)[Nm]
- (RAM) Turbine Distribution Factor (Turbine/Wastegate)[-]
- (RAM) Turbine MAF Target (After Corr.)[kg/h] *
- (RAM) Turbine Power (Actual)[kW] * *
- (RAM) Turbine Power (Base)[kW] * *
- (RAM) Turbine Power (P-Gain)[kW] * *
- (RAM) Turbine Pressure Ratio[-] *
- (RAM) Vehicle Speed[mph]
- (RAM) WGDC (Actual)[%] * *
- (RAM) WGDC (Adder)[%] *
- (RAM) WGDC (Base)[%] * *
- BM# Flex Ethanol % (Sensor) *
- BM# Flex Ethanol % *